← Back to Articles
Edit an Upstream OOB service group
Last Updated: July 07, 2026

This procedure assumes there is at least one Upstream OOB service group configured in the VTM.

  1. Select Service Groups from the navigation panel.
  2. Select the service group to be edited.

    If the list of Service Groups is too large to sort through, you can search for the relevant Service Group by using the Advanced Search field.

  3. Click the (Menu) button.
    The menu options appear.
  4. Click Edit.

    The Edit [Service Group] window is displayed. The window has the following potential tabs available:

    • Identity
    • Channels
    • RPDs
  5. Modify fields in the Identity tab as necessary.
    NOTE: The Type cannot be modified. If you selected the wrong type when creating this service group, delete the service group and recreate it with the correct Type selected.
  6. In the Channels tab, use or click the corresponding to remove a channel. You can also click the channel to modify the channel parameters.
  7. If the service group created channels, select or deselect RxDs in the RPDs tab. To configure the input Ethernet interface from which to receive content for an RxD:
    1. Select the checkbox next to the RxD and click All RF Ports, ENET 0.
    2. If the type is rpd 1x1 or rmd 1x1, then the service group has one upstream RF port. Click Ethernet Interface to select a different interface. If the type is rpd 1x2, rpd 2x2, rmd 1x2, or rmd 2x2, then the service group has two upstream RF ports. You can select different Ethernet interfaces for the RF ports.
      NOTE: By default, the RF ports are enabled and the Ethernet interface index is 0 for all RF ports.
  8. Click Update.

The service group has been updated and the VTM will provide the new configuration to the associated VUE and RxDs.