Static Pseudowire mode is only supported
for some devices and capture controls are dependent on the selected device.
NOTE: Static Pseudowire capture mode requires ServAssure Collection
Platform 2.11 or
higher.
NOTE: Some controls may not be configurable
depending on the vendor support and some fields retain their values from previous
captures.
For information on devices supporting this mode, refer to Upstream Spectrum capture summary.Capture controls for Static Pseudowire mode can include:
Start and end frequencies
- Start Frequency
- Starting frequency of the capture.
- End Frequency
- Ending frequency of the capture.
- Samples
- This is the number of samples
in the capture. Starting frequency and ending frequency, along with the
number of samples determine the resolution per point.NOTE:
Captures may have a variable resolution based on the sample count chosen (determined by the vendor device). A note can be shown below the Capture controls that identifies the resolution, for example:
Your settings result in a resolution of 100 kHz per point
- Domain
- The value for Domain is set to Frequency, indicating that amplitude is measured versus frequency (MHz).
- Capture Interval
- The number of seconds between samples. Value range is 0.05 – 1 second (50ms to 1000ms, inclusive).
- Service Identifier
- The Service Identifier menu lets you select either IdleFFT or Any options for the capture.